Mounting the control panel to the cabinet had a few rough spots. I ended up needing to sand the paint down so the bottom of the control panel would fit inside the cabinet properly.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEhjjkDDl5fcNKupko48t7d52VuEF4UGp9R_PULJRnDaMJ-8sUgOMiz0kD4gUMwLLAMjORzbGiAPSx1aBJr2pJWPqkq0Az0JnsaUHkiFPGxBUFhRmDMgdwwT9pJZjePREItG4066HzxVjrSb/s320/ControlPanelBase.jpg)
In this pic you can see the control panel base, without the control panel itself. I still need to order some clamps to hold it in place. Inside you can see where the black control panel bottom meets the white cross piece I mounted inside. That is where the clamps will go.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEjxzKeeLvl53U3sK3MB-YiWT-J5nyMtKo62cKojRFl-kwYyoY426hufdrLtjrSYUCaXbtPygacnyhZYNJnsXRPxzilHwW1xu2gWK6IPqUqhSuMVQ_B2_Rz_FIUlMs9nOUlbIhUuaTwVWmZr/s320/CPMounted.jpg)
The control panel slides out, once out far enough, I can reach inside and undo the two clamps holding the control panel to the base.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEhZswyehQGgp2sxanIl5gJNuY6SgzcM95qRo5grozrr36u-f9fGR4K6Xegg-V_x4jZgj5AO976q5hbE_OecdKaMjapNVrJXSGzjfQWTh-rZw8FX_qZF1oE0eov_253Dbl9Zg1ahMQwG4W16/s320/CPSlide.jpg)
It is a little hard to see the details of the control panel in place because of the lack of contrast of all the semi-gloss black surfaces.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEgI_f5gEyLOUmOos2AH5OzLhBnrh61KEuKyx86S0LmB3aosYbndbtiPaBCR5_nzH7SvfI-6-6uVjNyYGSPU8gxpQhzW92boIQ5RF25pK4y3Ps1KVdx8EgJN_PvniNT3GBFR_ZMKiCAt63nC/s320/CPMounted2.jpg)
From this angle the way the control panel meets the cabinet is more visible.
No comments:
Post a Comment